Keep an eye on it for a few normal regens just to make sure that it is not in a loop- not going to 100% fill before commencing and perhaps going down to 12 or 14% as the excessive regenerating will cause some fuel in the oil and before you know it your timing chain will rattle etc. Steering Angle Sensor (SAS)| Calibratethe steering wheel to straight ahead, or recalibrateSAS while steering part replacement. After cleaning or replacing the Electronic Throttle Body (ECTS), adaptation must be carried out (also the case if the negative terminal of the battery has been disconnected or when the Engine Control Unit has been replaced). I apologize ahead of time as the video quality may not be that great and it was all shot this morning using my phone while sitting in the car. I changed the oil after doing this, to make sure there was no dilution from extra injected fuel during the regen runs.

The iCarsoft scanners are excellent troubleshooting scanners but unfortunately we couldn’t find that many reviews online. It is not intended as, nor should it be considered a substitute for professional automotive advice or diagnosis. The early models of the iCarsoft scanners such as the i910 for BMW, i930 LandRover /Jaguar and i980 for Mercedes-Benz have been around for a while and many of you loved these scanners. The quick answer is that there are quite a few different sources for the hardware, and for the software.

Engine (ECM) | Function supports routine maintenance of engine modules, for example reset or delete the adaptation values and calculate fuel consumption. The signal is mainly used by the ABS System as part of it's stability control function but also by other systems such as ride level control and adaptive lighting. A hand-held diagnostic tool, offering FULL SYSTEM Diagnostic coverage including Engine, Transmission, ABS, Airbag, Air Suspension and so so much more.

Evap System Test| The EVAP test function lets you initiate a leak test for the vehicle's EVAP system.The other way of finding this information out is hook up a manufacturer's tool to the car, press a button and spy on the CAN traffic, ie reverse engineer them. In the very early days a "good" one had a Red circuit board, but then the poor quality ones started using red, so the colour now means nothing, nor the "Chinese" AAAA 1111++++ quality ratings, this is just "salesman bull".