Suitable for Light Vehicular Use On Dense Grade Projects. (For permeable driveway installs Refer to EASYJoint Pro) Maintain the Width of Joint Throughout. Maintain at least a 3mm gap width throughout the depth of the paving material. Never have this type of paving butted together. See photograph. IMPORTANT The project’s ground conditions must be free draining. If the area stays naturally wet and rarely dries out, or if there is a high water table, then EASYJoint should not be used. To further aid this, “point” or “strike” the joint; do not leave it textured. This ensures the top of the filler is below the top rounded edge of the paving and helps it adhere to the base and sides of the paving material. For a project to be free draining, both the bedding and sub-base must be permeable. To achieve this, assuming a permeable sub-base, where a mortar bedding is used it should be no stronger than 6 parts sand to 1 part cement (6:1). This will ensure good drainage and is perfectly adequate for pedestrian areas. If water is retained in the joint for long periods, rather than passing through, the joint may fail. Weather Conditions

EASY Joint gives you a much greater working window than other joint materials like polymeric sand. It is installed wet! You can now cut wet to eliminate dust, wash your patio off and finish jointing your patio all the same day! EASYJoint can be applied in virtually any weather conditions, however it is best practice to ensure that ground temperatures are greater than 3 degrees during the grout installation. Once installed, freezing conditions will not impair EASYJoint All Weather Jointing Mortar.The wash and sweep in application method makes it easy to use and jointing paving is faster than traditional methods Wet the Paving. Thoroughly soak the patio or paved area to be jointed with lots of water using a hose. The paving must be absolutely saturated before starting and remain soaked throughout the application process ‘the wetter, the better.’ We strongly recommend not shortcutting this process, particularly when working with absorbent or sensitive materials such as Sandstone, Granite and Limestone. Highly absorbent and porous stone will require sealing, 2-3 days prior to laying, on its top surface and four edges.

EASYJoint is the original sweep-in all-weather jointing compound and still the best truly "All Weather Paving Joint Compound". Do not be fooled by other paving jointing compounds making similar claims. Azpects sells tens of thousands of tubs of EASYJoint every month to satisfied customers all over the Europe and North America. Any dates specified by Building & DIY Supplies for delivery of the Goods are intended to be an estimate and time for delivery shall not be made of the essence by notice. If no dates are so specified, delivery shall be within a reasonable time. Additionally, ensure the project has a suitable “fall” to allow surface water to drain away. Base MixLess water is needed when applying EASYJoint to porcelain paving, as there is little risk of residue staining. You will find that a small amount of water, added to form it into a slurry, will make it easier to fill the joints properly. When applying to porcelain, to ensure an effective joint, the operator MUST strike the joint off, to compact the grout fully. Compaction forces out air and water which helps the joint harden faster.